The PCBite SP10 probes provide hands-free test point access for your multimeter, logic analyser, or oscilloscope. Simply position the spring-loaded test needle on any test point or component pad and release — the magnetic base holds the probe firmly in place for instant measurements or extended triggering sessions.

The minimalist design and fine 0.5 mm probe tip make it possible to measure on fine-pitch components and nearby signals simultaneously. Each probe base contains a powerful magnet compatible with PCBite metal base plates. This four-pack is ideal for those who already have a base plate and holders.

Key Features

• Hands-Free Probing – Spring-loaded needle with magnetic base holds position without soldering
• 0.5 mm Probe Tip – 30° tip angle for fine-pitch component access
• Low Needle Resistance – Less than 0.02 Ω for accurate measurements
• 2.54 mm Dual Pin Header – Dupont-compatible connector fits directly onto standard headers
• Versatile Connectivity – Includes Dupont-to-Dupont and banana-to-Dupont test wires

Specifications

• Model – SP10
• Attenuation Ratio – 1:1
• Bandwidth – >10 MHz (probe and cable are not impedance matched; suitable for measurements below 10 MHz, tested above 25 MHz with correct data decoding on common logic analysers)
• Rise Time – 34 ns (calculated)
• Maximum DC Current – 2 A
• Overvoltage Protection – 200 V DC + peak AC
• Safe Input Voltage – ±60 V DC, 30 V AC RMS, ±42.4 V peak max (per EN 61010-031:2015)
• Probe Tip Diameter – 0.5 mm
• Probe Tip Angle – 30°
• Operating Environment – −40 to +80 °C, 0–80% RH (max altitude 2 km)
• Storage Environment – −40 to +80 °C, 0–80% RH (max altitude 15 km)

Ideal For

• PCB development and verification
• Board-level repair and diagnostics
• Signal probing with multimeters, oscilloscopes, and logic analysers

Package Contents

• 4× PCBite SP10 probes with pin-tipped test needles
• 4× Extra test needles
• 5× Dupont-to-Dupont test wires
• 2× Banana-to-Dupont test wires

Resources

• User Guide (PDF)